From d9bf1ee6bc6036c2485c6b3b1aa4f28311734a7d Mon Sep 17 00:00:00 2001
From: Jakob Stendahl <14180120+JakobST1n@users.noreply.github.com>
Date: Sat, 3 Nov 2018 12:48:09 +0100
Subject: :memo: Add perfboard-layout and comments

---
 README.md | 12 +++++++++++-
 1 file changed, 11 insertions(+), 1 deletion(-)

(limited to 'README.md')

diff --git a/README.md b/README.md
index 14e59a0..14f78a0 100644
--- a/README.md
+++ b/README.md
@@ -17,4 +17,14 @@ This was made for a halloween-costume. The code runs on an attiny85, mainly to b
 
 # Schematic
 ![Schematic](https://raw.githubusercontent.com/JakobST1n/Stickman-Costume/master/StickmanCostume.png)
-`R2` and `R3` should be around __1K__.
+`R2` and `R3` should be around __10K__.
+## Layout
+![Layout](https://raw.githubusercontent.com/JakobST1n/Stickman-Costume/master/ProtoboardLayout.png)
+
+This is the layout i ended up with on my proto-board. The grey wire is the only "jumper" that was put on the top side of the board. All the other wires are "solder-traces" on the bottom side.
+
+I did not use a full-size through-hole voltage-regulator, but a AMS1117-3.3 on the bottom.
+
+Since i didn't have a 8-pin din IC socket i used a 14-pin one, but that does not make a difference either. 
+
+The red lines on the far right, is just an explanation of where i soldered my In-Out wires, They are not actually wires, but i soldered wires in where they start. This is the "same" thing as `J1` and `J2` on the scematic.
-- 
cgit v1.2.3