diff options
| -rw-r--r-- | README.md | 12 |
1 files changed, 11 insertions, 1 deletions
@@ -17,4 +17,14 @@ This was made for a halloween-costume. The code runs on an attiny85, mainly to b # Schematic  -`R2` and `R3` should be around __1K__. +`R2` and `R3` should be around __10K__. +## Layout + + +This is the layout i ended up with on my proto-board. The grey wire is the only "jumper" that was put on the top side of the board. All the other wires are "solder-traces" on the bottom side. + +I did not use a full-size through-hole voltage-regulator, but a AMS1117-3.3 on the bottom. + +Since i didn't have a 8-pin din IC socket i used a 14-pin one, but that does not make a difference either. + +The red lines on the far right, is just an explanation of where i soldered my In-Out wires, They are not actually wires, but i soldered wires in where they start. This is the "same" thing as `J1` and `J2` on the scematic. |