diff options
| -rw-r--r-- | README.md | 11 |
1 files changed, 7 insertions, 4 deletions
@@ -2,10 +2,10 @@ This was made for a halloween-costume. The code runs on an attiny85, mainly to be able to dim the lights down. # Usage -- Upload the code to the attiny -- Solder together the board -- Make the costume -- Have fun! +1) Make the costume +2) Solder together the board +3) Upload the code to the atiny +4) Have fun! ## Operation - Hold button `SW2` to change brightness/ pwm frequency. - Click button `SW1` to go through the modes. @@ -28,3 +28,6 @@ I did not use a full-size through-hole voltage-regulator, but a AMS1117-3.3 on t Since i didn't have a 8-pin din IC socket i used a 14-pin one, but that does not make a difference either. The red lines on the far right, is just an explanation of where i soldered my In-Out wires, They are not actually wires, but i soldered wires in where they start. This is the "same" thing as `J1` and `J2` on the scematic. + +# Todo +- I have a problem where it looks like it returns to mode `0`. I Haven't really figured out if this is due to bad code or bad soldering (or both). But there are a lot of improvements that could be done to the code, reagrding checking button presses. |